UNPLUGGED BAR BIKE CODE

For the next steps, please reach out to our Member Support Team with the results of steps 7 and 8.Reconnect the Bike+ to its original configuration.

UNPLUGGED BAR BIKE CODE

If left powered on, the touchscreen may display error code X0101, this is expected. Take the power adapter cable that's connected to the base of the Peloton Bike+ and connect the USB-C connection to the power port on the touchscreen (the middle port).Rotate the touchscreen and unplug the power cable located within the middle port.Unplug the power cable connected at the base of the Peloton Bike+.If there is no sound and the brake assembly does not move, proceed onto step 8 before contacting Member Support for additional assistance.Once powered on, you should see the brake automatically move toward and away from the flywheel to calibrate the Bike+.Īfter the power cycle, there should be an audible hum as the brake assembly moves up and down.

Confirm that the Peloton Bike+ performs an upwards and downwards calibration sequence within the brake shroud.

Once dissipated, remove the rubber grommet and reconnect the power cable back into the wall outlet and the Bike+. Wait until the white light on the power cable dissipates (this process can take up to 5-10 min).

Leave the power cable disconnected from the Bike+ and unplug the power cable from the wall outlet.

If the connector seems to be loose/bent/out of socket, please contact Member Support for additional assistance.

Disconnect the power cable from the base of the Peloton and inspect the condition of the connector.

To prevent damage to the power adapter from sweat and spills that may result in property damage or bodily harm, ensure the power cable does not run underneath the Peloton Bike+.

Power Requirements: 100V to 240V, 50Hz to 60Hz, 3.25 A Max.

(images 1.6, 1.7) If disconnected, reconnect the cable to the frame.

Check USB-C located on the inside right of the frame beneath the 'n' on the Peloton logo.

Check the USB-C connection inside the frame. Apply light pressure to ensure that the connector is fully inserted.

Verify that the cable above the brake shroud is connected to the top port.

Check the USB-C connection on the brake shroud.

Ensure the USB-C connection is going into the middle port on the back of the touchscreen.

Check the USB-C connection on the touchscreen. If the problem persists, please contact Member Support for additional assistance.

If there is no white light or the white light appears to be blinking, try connecting to a different outlet.

Check the status of the power adaptor cable located at the back of the Bike+. If you have a Peloton Bike, please refer to the Peloton Bike No Power Troubleshooting article.ġ. The reason for the 100 charge cycle for the first cycles is so that your battery can balance. When charging a battery to 100, for more range, don’t leave it like that for more than a day. Doing so will give you the best battery life. To resolve the issue, please follow the troubleshooting steps below. Try and charge to 80 and discharge until 20. If you are experiencing issues powering on your Peloton Bike+, this may be a result of a loose or incorrect connection.

Unplugged bar bike